This Is A Direct Replacement OE Style Division Bar Glass Channel Run.
This Direct Fit Channel is the Division Bar Run Front Door Glass Weather Strip Channel Run.
This Weatherstrip Channel goes in the Front of the Front Door Window Behind the Vent Glass going down inside the door.
This glass run weatherstrip will fit all Jeep Cherokees & Wagoneers as well as Jeep Comanches from 1984-1996.
This glass run weatherstrip will fit both the driver & passenger front door.
Save When Purchasing A Pair.
This Is A New Exclusive Part Made For Team Cherokee.
THE DEALER CHARGES ABOUT $140.00 EACH INDIVIDUAL SEAL.
SAVE HUGE OVER THE DEALER LIST ON THIS OE SEAL.
Why Pay $140.00 For One Seal When You Can Get A Pair For Less Than Half The Price Of One OE Seal.
REPLACES OE DIVISION BAR GLASS RUN PART# 55002337
TEAM CHEROKEE FRONT DOOR DIVISION BAR GLASS RUN PART# 55002337
# 12 ON THE DIAGRAM
Previous | Showing reviews 6-10 of 14 | Next
Posted by Scott S on 23rd Jul 2020
Seal fits well, managed to install it without removing the window. You just need plenty of lubrication!
Posted by Unknown on 8th Jan 2020
I ordered a complete set to replace all the weatherstrip on both doors of my 1994 2 door Cherokee. These division bar ones were hard to find and where I did find them, they didn't have the rest of what I needed. TeamCherokee had everything available.
Posted by LJ on 18th Apr 2019
Happy to have found this web site. Lots of needed parts for mh xj
Posted by running hot okie on 8th Sep 2018
my old weatherstrip just broke out in chunks that the easy part. did not remove complete channel for install of new channel. loosen lower mount bolt use lots of soapy water [spray bottle] on channel and weatherstrip push down on weatherstrip while rocking the window it should go down about 6'' before it get stuck,now install weatherstrip in the channel roll window up and down about 3 times while adding soapy water. roll window down rock glass keep pushing down to you can grab weather strip and pull down while rocking the glass. be sure to not to pull down to far. I used this method on both my doors took about about one hour on my first door and about half on the other. this is one tough and factory looking product. Hope this helps.
Posted by Bill on 25th Jun 2018
Great job on this repro piece for the classic XJ and MJ! Perfect fit, even has the hole punched to put a screw in it to hold it in place.